$L a T e X$ normally chooses the appropriate font and font size based on the logical structure of the document (e.g. sections). In some cases, you may want to set fonts and sizes by hand.

Introduction

The syntax to set a font size or font style is easy:

This is a simple example, {\tiny this will show different font sizes} and also \textsc{different font styles}.

This example shows how to use the smallest available font (tiny) in $L a T e X$ and the small caps style.

Open an example in ShareLaTeX

Font sizes

Font sizes are identified by special names, the actual size is not absolute but relative to the font size declared in the \documentclass statement (see Creating a document in LaTeX).

In this example the {\huge huge font size} is set and 
the {\footnotesize Foot note size also}. There's a fairly 
large set of font sizes.

In the example, {\huge huge font size} declares that the text inside the braces must be formatted in a huge font size. For a complete list of available font sizes see the reference guide.

Open an example in ShareLaTeX

Font families

By default, in standard $L a T e X$ classes the serif typeface (a.k.a. roman) font is used. The other font typefaces (sans serif and typewriter, a.k.a. monospace) can be used by entering some specific commands

In this example command and switches are used. 
\texttt{A command is used to change the style 
of a sentence}

\sffamily
A switch changes the style from this point to 
the end of the document unless other switch is used

You can set up the use of sans font as a default in $L a T e X$ document by using the command:

 \renewcommand{\familydefault}{\sfdefault}

Similarly, for using roman font as a default:

 \renewcommand{\familydefault}{\rmdefault}

Open an example in ShareLaTeX

Font styles

The most common font styles in $L a T e X$ are bold, italics and underlined, but there are a few more.

Part of this text is written \textsl{in different 
font style} to highlight it.

In the example at the introduction the small caps style was used. In this case the \textsl command sets the slanted style which makes the text look a bit like italics but not quite. See the reference guide for a complete list of font styles.

If you want to go back to "normal" font style (default for the $L a T e X$ class you are using), this can be done by using the \textnormal{...} command or the \normalfont switch command.

Open an example in ShareLaTeX

Reference guide

Font sizes

Command	Output
\tiny
\scriptsize
\footnotesize
\small
\normalsize
\large
\Large
\LARGE
\huge
\Huge

Default font families

typeface = family	command	switch command
serif (roman)	`\textrm{Sample Text 0123}`	`\rmfamily`
sans serif	`\textsf{Sample Text 0123}`	`\sffamily`
typewriter (monospace)	`\texttt{Sample Text 0123}`	`\ttfamily`

Font styles

style	command	switch command
medium	`\textmd{Sample Text 0123}`	`\mdseries`
bold	`\textbf{Sample Text 0123}`	`\bfseries`
upright	`\textup{Sample Text 0123}`	`\upshape`
italic	`\textit{Sample Text 0123}`	`\itshape`
slanted	`\textsl{Sample Text 0123}`	`\slshape`
small caps	`\textsc{Sample Text 0123}`	`\scshape`